Using smcFanControl I know the fan is running at 29C and average 996rpm. I don't know if those stats are normal or not, but my fan is still making more noise than it ever has. Its been a while since i did this, i might be wrong Make sure smc is reset by holding down the power button for 5 seconds, forget what apple says about waiting 15 seconds, that should guarantee that the smc is reset Can anybody suggest anything outside of taking it to apple because that is my last resort which is going to cost me a lot of money I very worried that using my Mac is going to damage something and I desperately need it for work. Like SandboxGeneral and maflynn says it could be a lose wire. Or you installed a hard disk without a sensor wire.īut if you run apple hardware test in extended test, it should tell you that there is something wrong with the fans or sensor, it will spit out an error code if there is something wrong with the fans/temp wires. Then you need to go to the genius bar and use genius bar diagnosis test to check the fans and temperature sensors, last time i ran the genius bar test it made it look like my mac book air had more then 10 temp sensors. I asked the genius over there once what was the difference between apple hard ware test and genius diagnostics, he said nothing at all. Please, can somebody help! I have been trying for weeks now with no success.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |